Upgrade Instructions for RoadRunner Rev 2.00

1.) Create a directory named RR200
2.) Unzip the file "RRREV200.zip" to the RR200 directory
3.) Connect a DB9 Pin to Pin straight through cable from the RS232 port of a
    PC to the UPGRADE & CONTROL RS232 port of the RoadRunner
4.) Power up the RoadRunner while holding the "Up Arrow" until the word "HOLD"
    appears on the LCD screen
5.) From the RR200 directory, type LOAD 1, for COM1 or LOAD 2, for COM 2
    and press Enter
6.) The PC screen should display:
         trying baud rate 1200
         trying baud rate 2400
         trying baud rate 4800
         trying baud rate 9600
         Connected to CDQPrima
         shifting to 38400 for transfer
7.) Allow the first part of the download to complete, the PC screen will clear,
    and display:
        Control and DSP Download Complete
        Power down the RoadRunner, Power back up and do a "1" reset(see below)
        wait for boot process to complete,
        Press any key to continue        
8.) To perform a "1" reset, Power Up the RoadRunner while holding the "1"
    key until the words "PARAMETER RESET REQUEST" appear on the LCD and
    release the "1" key
9.) Press any key on the PC, and the Pre-Programmed Quick Configurations
    will be loaded.
10.) Upgrade is complete